Smalvic BTO953PET Instructions Pour L'utilisation Et Manutention page 9

INSTALLATION INSTRUCTIONS
These instructions are for a specialized
installer and are a guide for the installation
process, regulations and maintenance
in accordance with the law and current
standards. If the built-in oven or any
other appliances that produce heat,
need to be installed directly underneath
the cooking hobs in ceramic glass, IT IS
NECESSARY THAT THE APPLIANCE
(oven) AND THE COOKING HOBS IN
CERAMIC GLASS ARE ADEQUATELY
ISOLATED. Failure
precaution, could cause a malfunction in
the TOUCH CONTROL system.
POSITIONING
The domestic appliance was built in order
to be encased on a work surface, the
way it is illustrated in the graph (Fig.1).
Predispose sealing material along the
whole perimeter Fig. 4 (the dimensions of
the cut Fig.1). This operation is necessary
to avoid any liquids penetrating the work
top, as it is not possible to guarantee that
the top, the glass and their connection
are completely flat. Lock the domestic
appliance into place with 4 supporters,
keeping in mind the width of the surface
(Fig.2). If the lower part of the appliance
after installation, is accessible via the
lower part of the furniture, it is necessary
to mount a separating panel keeping in
mind the distances indicated (Fig.3) if the
appliance is being installed underneath
an oven, this is not necessary.
The appliance is not inteded to be
operated by means of an external timer
or separate remote-control system.
to follow this
ELECTRICAL CONNECTIONS (Fig.5)
Before making the electrical connections,
check that:
- the system ratings meet the ratings
indicated on the identification plate fixed
on the lower part of the worktop;
- the system is fitted with efficient ground
wires in accordance with the laws and
current standards.
Grounding is mandatory by law.
If the domestic appliance is not supplied
with a cable and/or suitable plug, use
material suitable for the absorption value
indicated on the identification plate and
the operating temperature.
If wishing to make a direct connection to
the mains, an omnipolar switch must be
installed with a minimum 3 mm opening
between the contacts and appropriate
for the load indicated on the plate and in
accordance with current standards (the
yellow/green ground conductor must not
be disconnected by a switch).
When the appliance has been installed,
the omnipolar switch must be easily
reachable.
CLEANING AND MAINTENANCE
Remove any residues of food and drops
of grease from the cooking surface by
using the special scraper supplied on
request (Fig.7). Clean the heated area
as thoroughly as possible using suitable
products, and a cloth/paper, then rinse
with water and dry with a clean cloth.
Using the special scraper (optional)
immediately remove any fragments of
aluminium and plastic material that have
unintentionally melted on the heated
cooking area, or residues of sugar or food
with a high sugar content (Fig.7). In this
way, any damage to the hob surface can
be prevented. Under no circumstances
should abrasive sponges, or corrosive
chemical detergents, such as oven
sprays or stain removers, be used.
9