Trunk Support; Entry And Exit; Adjusting The Handle; Using The Rear Stop - Vela Meywalk 4 Manuel De L'utilisation

2.0.9. TRUNK SUPPORT

The trunk support is opened by moving the outer handles (on
the back) upwards. The trunk support is closed by sliding the
handles down again so that the opening is smaller. Note: The
trunk support must always be closed when the gait trainer is in
use.

2.0.10. ENTRY AND EXIT

Grab the front of the tilt bar* with both hands and tilt it. This
lowers the seat unit, which facilitates entry and exit (Micro
cannot be tilted). The seat unit is raised again by pressing down
SMALL,
the tilt bar until it locks in the click hook with an audible click.
MEDIUM &
Note: Close the trunk support (see section 2.0.9.) and rear stop
LARGE
(section 2.0.12.) when the gait trainer is in use.

2.0.11. ADJUSTING THE HANDLE

The angle of the handle is adjusted using two hand screws.
Turn the hand screws counterclockwise so that the handle
can rotate. There are three default settings of the handle.
Remember to tighten the hand screws again.
Note: The handle can be angled in a vertical position, so the
user has free access to e.g. a work table and kitchen table.

2.0.12. USING THE REAR STOP

The rear stop should always be locked up when the gait trainer
is in use. Swing the rear stop up so that it rests against the seat
and locks. Lift the rear stop up and swing it down to reopen
the rear stop when exiting the gait trainer.
*Never let go of the tilt bar when raising or lowering it.
1 4