Nordcap EC 3.5 Notice D'emploi Et De Maintenance page 6

Before using the appliance make sure that it is connected to a
socket with a suitable voltage and that there are no foregin
matters inside the feed hopper or ice bin because these could
cause the moving parts to lock.
The ise-crusher is only suitable for crushing ice in cubes.
TECNOINOX declines any responsibility in the case of
damage caused by improper use.
Press the main switch (A) to position 'I'. The pilot light will turn
on to indicate that the appliance is ready to use. If the light
should not turn on, check that the socket to which the
appliance is connected is powered.
Adjust the size of the cruched ice by regulating the knob (D)
located on the left inside the front compartment of the ice bin.
Do not wash the appliance with jets of water because if water
gets through to the electric components it could cause the
appliance and the safety systems to malfunction!
If the appliance is not going to be used for a long period of time,
disconnect it from the mains and clean it with soapy water, rinse
and dry it carefully. Spread a thin layer of Vaseline oil on the
surface.
WHAT TO DO IF THE APPLIANCE DOES NOT FUNCTION PROPERLY
Failure to function does not always depend on the quality of
the components used. Our appliances are manufactured using
top quality components. Failures may be caused by voltage
surges, or dust and dirt in the operating components.
The appliance does not require special maintenance except
for normal cleaning: however, we do suggest a yearly check-
up by the after-sales service centre for which we
Our appliances are studied and optimised, with lab tests, to
provide high performances and efficiencies. However, in order
to save on power (electricity, gas and water), we suggest you
do not use the appliance for a long time if it is empty or under
conditions that compromise optimum efficiency.
All packaging materials are environment-friendly. They can be
stored safely or burnt in a waste incinerator plant. The plastic
components that can be recycled are:
04/2004
SWITCH-ON, OFF AND OPERATION
CLEANING AND CARE
MAINTENANCE
ECOLOGY AND THE ENVIRONMENT
GB - 2
Check for the presence and position of the collecting bowl
inside the front compartment.
Load the ice cubes in the top feed hopper and shut the door.
Press the front button (B) for the time required to crush the
ice.
If the appliance does not start when the button is pressed,
check that the front and top doors are shut and try again.
If the doors are shut properly and the pilot light is on but the
appliance does not start when the button is pressed (B), turn
it off as explained further ahead and call the after-sale service.
To turn the appliance off simply turn the main switch to
position '0'. The pilot light will turn off.
Do not use sponges or abrasive products of any type. Do not
even use corrosive detergents such as oven-cleaner or stain-
remover sprays.
To minimise emission of polluting substances in the
environment we suggest cleaning the appliance with
products that are more than 90% biodegradable.
In any situation where improper functioning of the appliance is
suspected, turn it off and disconnect it from the mains. Call the
authorised after-sales service centre.
Unauthorised persons should never attempt to repair the
appliance or carry out maintenance. Tampering with the
appliance voids the warranty!
recommend you stipulate a maintenance contract.
• Polyethylene: external packaging material and/or pluribol
film
• Polypropylene: straps
• Polystyrene foam: corner pieces, sheets and protection
blocks.
At the end of the appliance's useful life, dispose of it
properly.
90% of each appliance is made in metal (stainless steel,
iron, aluminated sheet metal, etc.) hence it can be recycled
via the relative recycling organisations in compliance with
the standards in force in your country. Before recycling the
appliance make it unusable by removing the power cable.
5410.014.01