Publicité
Les langues disponibles
Les langues disponibles
EN
Special maintenance must be carried out by
personnel.
In case of failures or malfunctioning of the product, contact
onl authorised technicians to avoid losing warrant rights. The
manufacturer shall not be held responsible for an damage
caused b products that have been tampered with or repaired
wrongl .
Limescale can be removed from water jet
nozzles simpl b rubbing.
TROUBLESHOOTING
In the event of abnormalities run the following checklist.
All
electrical
connection
performed by an electrical installation technician.
If there is no response from the wall controls, check that:
- The switch is on.
- The appliance is powered. Check that the domestic power
suppl
is working b
appliances which ou know are operating correctl .
All
hydraulic
connection
performed by a hydraulic installation technician.
If the water is slow to drain awa , check that the drain is not
blocked.
If the product does not dispense water, check that:
- There is water in the main pipe.
- The diverter is correctl set.
- There are no impurit into the pipes that prevent normal
water ow.
If the above operations do not solve the problem, contact our
nearest service centre or the compan .
THERMOSTATIC MIXER
D
,
URING TESTING
THE THERMOSTATIC MIXER IS SET SO THAT THE
(
MECHANICAL STOP POINT
BUTTON ON LOWER PART OF KNOB
WARNING
If hot and cold water pressure in the piping s stem is not uniform,
further setting ma be necessar .
The appliance will not operate correctl if the s stem pressure
is below 120k Pa (1,2 bars). If the water mains pressure is over
250k Pa (2,5 bars), a pressure reducer must be tted upstream
of the s stem.
We recommend instal-ling resin lter (30/40 litres/minute) on
the deliver line in order to prevent foreign bodies etering the
circuit and damaging the mechanical parts of the mixer.
checkup
must
testing other electrical household
checkup
must
)
IS AT
WARNING
uali ed
The thermostatic mixer has a safet block at 38°. To reach a
higer temperature press the button and turn the handle (A)
be
anticlockwise.
turn the cock handle ( ) and place the central ax on the desired
function, as shown on the icon.
Turn the handle (A) to adjust the temperature.
E
XAMPLE OF FUNCTIONS THAT CAN BE SELECTED WITH THE COCK HANDLE
Shower head
be
Large head
Jets
B
38°
38°C.
-
38°
A
14
SETTING
38°
+38°
-38°
38°
38°
FUNCTIONING
38°
+38°
B
B
Publicité
