Publicité
Les langues disponibles
Les langues disponibles
• Pull out completely columns support 3 (Fig. 2) of
the slot mortising device from the pivoting plate.
• Slide support bracket 4 forwards until it engages,
if necessary release clamping lever 5 and push
guide rod 6 downwards.
• Release clamping levers 7 and 8, move guide
block 9 downwards as far as it will go by turning
handle 10 and retighten clamping levers 7 and 8.
Loosen the cylinder head bolt in handle 10 using
the hexagonal spanner (SW4) provided with the
LS 103 Ec and take off the handle.
• Now put the chain mortising machine LS 103 Ec
on guide columns 11 and secure by means of
knurled nut 12. Re-fasten handle 10 with the cylin-
der head bolt.
• To mount the chain bar support unscrew threaded
pin 13 after slackening off wing nut 14 so that the
mortising chain can be moved between threaded
pin 13 and bearing journal 15.
• Then release clamping lever 5, pull back support
bracket 4 and insert bearing journal 15 in the
groove of the chain bar.
Fig. 2
• Tighten threaded pin 13 so that support bracket 4
can be moved back- and forwards without play.
• Finally, secure threaded pin 13 with wing nut 14.
Fig. 1
-6-
Publicité
