Setup / Batteries - Health O Meter 1100KL Instructions De L'utilisateur

SETUP / BATTERIES

Preparing the 1100KL Scale for Use
1. Remove the protective plastic film covering the display head (the film is printed "FACTORY
CALIBRATED").
2. See Powering the Scale or Battery Installation, below, for battery and AC adapter
instructions.
Powering the Scale
1. Plug the AC adapter into the power adapter jack (the jack is located on the rear of the
display head), then plug the scale's AC adapter into the power source.
Warning: To avoid a safety hazard, do not use an unspecified AC adapter. Only use the Health
o meter® Professional AC adapter model ADPT30 designed for this scale.
2. For battery operation, see Battery Installation below.
Battery Installation
1. If connected, unplug the AC adapter from the power source.
2. Use a Phillips head screwdriver to remove the battery cover on the side of the display head
by unscrewing the (2) battery cover screws.
3. Replace or install fresh batteries, making sure to install them in the proper direction. Health
o meter Professional recommends using an alkaline or lithium battery, rated for 130°F
(54°C) operation. Do not use Zinc-Carbon batteries.
4. Re-attach the battery cover to the display head.
Warning: If the scale will not be used for some time, remove the batteries to avoid a safety
hazard. Disposal of batteries must be performed in accordance with the prevailing national,
regional or local regulations that apply to you.
Figure 8
12
Power Adapter
Jack