Publicité
Les langues disponibles
Les langues disponibles
2. Install the vac rack reusing the carry handle
screws. Put them back in their original holes
and tighten.
3. Use the 2 screws (bb) provided by placing
them in the rear holes of the vac rack. Push
down and turn each screw to break through the
material and into the hidden screw boss below.
Tighten.
CAUTION: Do not exceed 9 kg (20 lb)
in each 14 liter storage unit, maximum
2 storage units per dust extractor. Do
not exceed 18 kg (40 lb) in a 28 liter
storage unit, 1 storage unit per dust
extractor. Exceeding the recommended
height and/or weight could result in an
unstable dust extractor would could
cause injury or damage.
NOTICE: Do not remove dust extractor
head from tank with T-stack storage
units attached. Doing so could result in
damage to the dust extractor filters.
SECURING THE POWER CORD TO THE HOSE (FIG. 1)
The power cord (b) can be secured to the suction
hose (g) using the D279058CL hose clip (available
from your local D
WALT supplier).
E
Consult your dealer for further information on the
appropriate accessories.
Troubleshooting
PROBLEM
SOLUTION
Motor
Check power cord, plugs and outlet.
does not
Ensure the on/off /tool control switch
run
is in the ON position ( ).
Suction
Remove blockages in the suction
capacity
nozzle, suction tube, suction hose
decreases
or filters.
Replace the paper or fleece bag.
Check for proper installation of the
filters.
Clean or replace the filters.
Empty canister, refer to Empty
Canister under Operation.
PROBLEM
SOLUTION
Vacuum
Thermal overload has been tripped:
stops
1. Turn the vacuum off and
running
disconnect vacuum cleaner from
power source.
2. Empty the canister, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an
appropriate outlet and turn on/
off/tool control switch to the ON
position ( ) to test. If vacuum will
not restart contact your seller or
check the location of your nearest
authorised D
in the D
WALT catalogue or
E
contact your D
address indicated in this manual.
Dust
Check for proper installation of the
comes
filters.
out while
Ensure filters are not damaged;
vacuuming
replace if necessary.
Ensure filter seals are in place and are
secure.
Automatic
Listen for the solenoid clicking to
filter
ensure the filter cleaning mechanism
cleaning
is working.
is not
working
Power tool
Ensure the on/off/tool control switch is
does not
in the ACTIVATION position
turn on.
Protecting the Environment
Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
EN G LI SH
WALT repair agent
E
WALT office at the
E
.
WALT product
E
35
Publicité
