Input Menu - Fracarro KCPN Instructions D'emploi

After connecting the TPE to the KDF converter, the following menu items will appear: INPUT, OUTPUT, MEASU-
REMENTS.
Set country
Set signal ty pe
Select input
Select output
output lev el
Setting of an of f set
on the f iltering mask
Select normal or
inv erted spectrum
N.B. By operating on the 4 available steps of 15KHz, it is possible, by means of the "OFFSET IF" function, to
displace the channel that's to be converted as regards the central frequency of the SAW filters in IF and to cut the
side of the adjacent channel with the highest level.
Enter the INPUT with the
sponder and to the program to be selected.
INPUT
Enter the OUTPUT menu with the
to the standard remodulation.
OUTPUT
6.4 INITIAL MENU
KCPN
COUNTRY
SIGNAL TY PE
INPUT
f requency
OUTPUT
f requency
RF OUTPUT
Select RF
LEVEL
OFFSET IF
IF SPECTRUM
FW VERSION

6.5 INPUT MENU

arrow key or with the
INPUT
FREQUENCY
INPUT
CHANNEL
BANDWIDTH
6.6 OUTPUT MENU
arrow key or with the
OUTPUT
FREQUENCY
OUTPUT
CHANNEL
EUROPE
FRANCE
UK
AUSTRALIE
ANALOGUE
DIGITAL
Menu INPUT see page
Menu OUTPUT see page
OFF, 0, 1, ...,15
-4 -> -500KHz
-3 -> -375KHz
-2 -> -250KHz
-1 -> -125KHz
0 -> Freq.original
+1 -> +125KHz
+2 -> +250KHz
+3 -> +375KHz
+4 -> +500KHz
NORMAL
INVERTED
Ver. 0.0
key of the TPE to set the parameters relevant to the tran-
47-862MHz step 0.125MHz
Select by Kanal (the
range depends on the
selected country )
Channel bandwidth
key of the TPE to set the parameters relevant
47-862MHz step 0.125MHz
Select by Kanal (the
range depends on the
selected country )
15
15
15
Select by f requenz
Select by f requenz