Publicité
Les langues disponibles
Les langues disponibles
Grasp the water tank handle
Fill the water tank with water
3) Put the iron on the thermal insulation stand of unit base correctly (see
Fig.3).
4) Connect the plug to wall outlet, and then turn the temperature dial to select
your desired temperature setting, which is depended on the fabric of
garment. Refer to "IRONING TIPS" and "ADDITIONAL TABLE" as below
when select temperature.
5) And then the temperature indicator illuminates and the iron starts heating.
6) After a few minutes, the temperature indicator extinguishes, which
indicates the soleplate temperature has achieved the selected
temperature. And you can start ironing with steam now.
7) Press the steam trigger with a little force, the steam will be sprayed from
the soleplate continuously, and then you can iron the garment with steam.
NOTE: There may be dripping water during spraying steam when the
temperature is lower than that of the second setting. This is normal.
8) If you want to activate the "pressing" function to remove tough wrinkle,
continuously press the steam trigger twice to produce shot of steam.
CAUTIONS:
~ Do not touch hot soleplate at any time before cooling down!
~ Never direct the steam at people!
~ Do not activate the steam function when the iron is placed on the unit
base to avoid being scalded by steam.
9) After ironing, remove the plug from the wall socket and the appliance will
be turned off. But the soleplate is still hot, never touch it with hand, place it
on the thermal insulation stand correctly until it cools down completely.
Remove the water tank horizontally
Replace the water tank
EN-12
Fig.4
Publicité
