Publicité
Les langues disponibles
Les langues disponibles
BEFORE FIRST USE
(1)
Remove any sticker or protective foil from the soleplate.
(2)
Fill the water tank with water and heat up the iron at the maximum
temperature, and then iron over a piece of damp cloth for several minutes
for the purpose of removing any residue on the soleplate according to the
section of "Steam ironing".
NOTE：
• It is normal that strange odour comes out from the unit for the first use. This
will cease after a few uses.
• Some particles may come out of the soleplate when you use the iron for the
first time.
This is normal, the particles are harmless and stop coming out of the iron
after a short while.
INSTRUCTIONS TO USE
The appliance has two ironing ways. You can use dry ironing or steam ironing;
the details refer to the following.
Dry ironing
1) Put the unit base on a stable and level surface.
2) Put the iron on the thermal insulation stand of unit base correctly (see
Fig.3).
3) Connect the plug to wall outlet, and then turn the temperature dial to select
your desired temperature setting, which is depended on the fabric of
garment. Refer to "IRONING TIPS" and "ADDITIONAL TABLE" as below
when select temperature.
4) And then the temperature indicator illuminates and the iron starts heating.
5) When the temperature of soleplate reaches the selected temperature, the
temperature indicator turns off, and you can start ironing now.
WARNING:
Steam ironing
1) Put the unit base on a stable and level surface.
2) Grasp the water tank handle and then pull out the water tank horizontally,
fill the water tank with water through the filling aperture and then replace
the water tank well in position (see Fig.4). Make sure the water tank shall
be pulled out horizontally when removing the water tank. You had better
use purified water with less calcium particles. The maximum capacity of
water tank is 1.2L, the water level shall not be exceeded the maximum
level.
Never touch hot soleplate at any time before cooling down!
EN-11
Publicité
