Settings Menu; Balance Recovery / Alarm Level - Fisher & Paykel AquaSmart WL37T26C Instructions D'installation Et Guide De L'utilisateur

After using your AquaSmart™ washer you may wish to fine-tune some of the options to suit
your individual needs. Any options changed in this menu are a permanent change, unless 'Reset
Defaults' is selected (refer to page 35).
To access the Settings Menu:
Turn your AquaSmart™ washer on.
1
Scroll, to the right, through the wash cycles until you reach the Settings Menu.
2
Press SELECT to enter the menu.
3
Balance Recovery
When your washer is spinning it can sense if the wash load is out of balance. It will
stop and try to spin up to three times. If the washer still senses an unbalanced load,
there are two options the washer can take:
1. Out of Balance Recovery OFF
Your washer is automatically set to the Out of Balance Recovery OFF option. When
this option is on, your washer will give a short burst of beeps every five seconds to
alert you. It will then ask you to redistribute the load before continuing the cycle.
Your washer defaults to this setting.
2. Out of Balance Recovery ON
Your washer will try to automatically correct the out of balance load twice. It will fill
with water and 'agitate' to redistribute the load before trying to spin again.
To set Automatic Recovery:
Access the Settings Menu (refer above).
Scroll to the OUT OF BALANCE RECOVERY option, and press SELECT.
Scroll to select between the two options.
Press SELECT to confirm your selection and return to the Settings Menu.
Alarm Beeps
The number of beeps that signal the end of the cycle can be altered. Choose
between no beeps, five or fifteen beeps.
Access the Settings Menu (refer above).
Scroll to the ALARM BEEPS option, and press SELECT.
Use the SCROLL buttons to adjust the number of beeps.
Press SELECT to confirm your selection and return to the Settings Menu.

Settings Menu

33
EN