_________________________________ ___EN__________________________________27
Clock set
The clock is for a 24-hour system and the initial time is 00:00. To make a better
use of this appliance, it is recommended to set the time for accurate local time. Every
time powered off, the clock will be reset to the initial time 00:00.
Method for time set:
Mode selection
The appliance is enhanced with three operation modes: Economy Mode, Hybrid
Mode and E-heater Mode.
a) Economy Mode: the appliance heats water only by compressor drive
according to heat pump principle. It is used when the ambient temperature is high
(15°C ).
b) Hybrid Mode: the appliance heats water basically by heat pump, but when the
ambient temperature is low (15°C ), the electric heater also starts to operate.
c) E-heater Mode: The appliance heats water only by electric heater. It is used
when the ambient temperature is very low.
By default, the appliance operates in Hybrid Mode.
Mode Change:
Press the CLOCK key, the minute of the the minute
digit of the clock on the display starts flashing slowly.
Press the „UP" and „DOWN" key, you can adjust the
minute.
Press the CLOCK key again, the minute digit stops flashing
while the hour digit starts flashing.
Press the „UP" and „DOWN" key, you can adjust the hour
to set the clock.
Press the „CLOCK" key again and wait about 10 seconds,
flashing stops and CLOCK SET is finished.