Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
_________________________________ ___EN__________________________________25
6.1.
Control panel explanation
6.2.
Display explanation
HIGH TEMP indicator: When the setting temperature exceeds 50 °C, it lights up to
1
remind you that the outlet temperature is too high for direct spray.
FILL WATER indicator: When the power supply is turned on, it lights up to remind you to
2
re-affuse water.
ALARM indicator: it flashes continuously at malfunctioning or protection time. .
3
TEMP-SET indicator: it shows the setting temperature at blank during screen protection.
4
Codes are shown at malfunctioning or protection time.
LOCK indicator: when the user interface is locked, it always lights.
5
Water temp. indicator: when the actual water temperature exceeds 60 °C, it lights up.
6
Water temp. indicator: when the actual water temperature exceeds 50 °C, it lights up.
7
Water temp. indicator: when the actual water temperature exceeds 40 °C, it lights up.
8
OUTLET TEMP indicator: it displays water temperature of the upper part of the tank,
9
which can be used. It always lights.
TIMER CONFLICT indicator: When the temperature you set through Wired Controller
10
conflicts with that through User Interface, it lights up.
TIME OFF indicator: It will light up when timing off mode is set, blanks during screen
11
protection.
TIME ON indicator: It will light up when timing on mode is set, blanks during screen
12
protection.
CLOCK indicator: It displays present time, it blanks during screen protection.
13
E_HEATER MODE indicator: When the user sets the E-heating Mode, it lights up.
14
HYBRID MODE indicator: When the user sets the Hybrid Mode, it lights up.
15
1
2
16
15
14
13
12
Display
Operation
3
4
9
10
11
5
6
7
8
Publicité
Chapitres
Table des Matières
