Electrical Ratings - Honeywell HZ-2300 Guide D'utilisation

13. Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire, or damage the heater.
14. To prevent a possible fire, do not block air intakes or exhaust in any manner.
Do not use on soft surfaces, like a bed, where openings may become
blocked.
15. A heater has hot and arcing or sparking parts inside. Do not use it in the
areas where gasoline, paint, or flammable liquids are used or stored.
16. Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury
to persons.
17. The output of this heater may vary and its temperature may become intense
enough to burn exposed skin. Use of this heater is not recommended for
persons with reduced sensitivity to heat or an inability to react to avoid
burns.
SAVE THESE INSTRUCTIONS
18.

ELECTRICAL RATINGS

This product is rated 12.5 amps (1500W) at 120V, 60 Hz.
OPERATION
• Place the heater on a firm, level surface free from
obstructions, and at least 3 ft. (0.9m) away from any
wall or combustible material.
• With the selector knob in the OFF position, plug the
heater into a polarized 120V outlet.
• Turn the thermostat control fully clockwise to the HIGH
setting.
• To turn the heater on, push down the child resistant
switch (Selector knob) while turning it clockwise to the
desired position (Fig. 1) (HIGH for 1500W, MED for
900W, or LOW for 600W). The power light will illuminate.
• When the room reaches a comfortable temperature, slowly turn the thermostat
control counter-clockwise until the heater goes off. This is the point at which the
thermostat setting equals the room temperature. At this setting, the thermostat will
automatically turn the heater on and off to maintain this selected temperature.
• If using the oscillation feature, at the point your desired temperature is reached, the
heater will stop oscillating.
• Push down and turn the Selector knob to OFF and unplug the heater when you are
finished using it.
FIG.1