Fitting The Lamp; Flint Ignitor Fl; Function Check - Truma LZS Mode D'emploi / Instructions De Montage

Fitting the lamp

To achieve the best brightness the lamp is to be fitted at the
highest point in the room.
When using the short pendant (6) with 10 cm length an ad-
ditional heat deflector with 50 cm diameter must be fitted to
the ceiling.
When using the pendants with 20 or 40 cm length the Truma
heat deflector (7) Ø 22 cm (part no. 10660-00) can be fitted for
wooden ceilings.
Screw the elbow fitting (5) to the ceiling and connect the gas
supply line. Slide the heat deflector (8) over the pendant (6)
and screw on together with the lamp to the elbow fitting.
For sealing the thread connections use Teflon tape or
hemp with Truma paste. Do not use any sealing
fluids!
Before fitting the globe (9) unscrew the two knurl nuts on
the supporting bar. Put the globe with a tilting movement be-
tween the cap of the globe and the supporting bar and slightly
tighten the knurl nuts.
For cleaning take it off the other way around without remov-
ing the mantle.
8

Flint ignitor FL

Additionaly the lamp can be fitted with a flint ignitor (10 – part
no. 10000-05500). Remove the globe (9) and clamp the igni-
tor to the supporting bar on the opposite side of the valve rod.
For the correct distance to the mantle the ignitor should be
fixed on the outer side of the supporting bar. For operating
pull down the grey button (1) and turn the knurled bar on the
ignitor abruptly to the right. If the flint is used, replace by a
new one (available in trade for lighters).

Function check

Before the first operation the appliance and the complete gas
installation (according to the pressure drop method) must be
checked by an expert.
Then check all functions of the appliance, as specified in the
operating instructions.
The operating instructions must be handed to the owner of
the vehicle.