Brother P-touch PT-9600 Manuel D'emploi page 71

6 Check that the installation will be carried
out as desired, and then click the Next but-
ton. A dialog box appears, indicating that
the printer driver has been installed.
7 If the port where the PT-9600 is connected
supports a baud rate of 9600 bps, click the
Next button.
If the port where the PT-9600 is connected
does not support a baud rate of 9600 bps,
or if you wish to check the connection
between the P-touch and the computer,
select "Start up the Change Baud Rate Wiz-
ard.", and then click the Next button. The
Change Baud Rate Wizard starts up.
To change the baud rate:
8 Select the serial port where the PT-9600 is
connected, and then click the Next button.
A dialog box appears, allowing you to
select the desired baud rate.
Ch. 4 Advanced Functions
9 Select the desired baud rate, and then click
the Next button.
NOTE
Normally "9600 bps" is selected; however, your
computer may not be able to support a baud rate of
9600 bps. If this is the case, refer to the computer's
instruction manual, and select the maximum possi-
ble baud rate.
A dialog box confirming the settings
appears.
0 Check that the baud rate will be changed as
desired, and then click the Next button.
NOTE
To change the settings, click the Back button, and
9
return to step .
A dialog box appears, showing that the
baud rate has been changed as specified.
61