Dorel Maxi-Cosi EasyFix Mode D'emploi & Garantie page 6

EN
B. Adjusting the length of the support leg
IMPORTANT!
Always use the support leg to ensure
the safe use of the EasyFixT
IMPORTANT!
Make sure the support leg is fully
8
folded out and locked at the hinge pointT
• Keep the silver control button on the support leg
9
pressed and move the support leg downwards
until it reaches the floor of the carT
IMPORTANT!
Make sure the indicator at the base of
10
the support leg is greenT
• In some cases the EasyFix may not be fully
supported by the car seat, but entirely by the
support legT
• Release the control button and "click" the support
leg into the locked positionT
• Check to make sure the support leg is securely
locked and stays in position by trying to move it up
or down without pressing the control buttonT
12
Checklist...
To ensure the optimum safety of your child, check
the following after installation:
• Both Isofix connectors are securely attached to the
Isofix anchor points: the indicator on the central
button on the support leg should be greenT
• The support leg is fully folded outT
• The indicator on the base of the support leg
is greenT
• The entire EasyFix is installed securely and firmly
in the car (check by pulling on the EasyFix)T
C. Removing the EasyFix
• Restore the support leg to its start position by
11
pressing the control button and sliding the support
leg upwardsT
• Disconnect the Isofix connectors by pressing the
12
central button on the support legT The indicator on
the central button on the support leg should be
redT Considerable force may sometimes be needed
in orrder to release the buckleT If this is the case, try
pushing the EasyFix into the back of the vehicle seat
while pressing the release buttonT
• Remove the EasyFix from the Isofix anchor pointsT
13
• Remove the EasyFix from the carT
3
1
2
3.2 Using a 3-point safety belt (blue marking on
product) and support leg
If your car is not equipped with Isofix anchor points,
you can install the EasyFix using a 3-point safety belt
in combination with the support legT To check whether
your car is suitable for installation using a 3-point
safety belt and support leg, see Section 9: Car fitting
listT
EN
• Installation with 3-point safety belt
• Installation with 2-point safety belt
1 2
• On passenger seat
• On left/right side of back seat
• In middle position of back seat
• Belt routing marking
• Frontal airbag
• Side airbag
* Provided there is a 3-point safety belt in the middle
position of the back seat and there is enough room
for properly installing the support leg (see Section
9: Car fitting list)T
Only install the EasyFix on a forward-facing seat fitted
with an automatic 3-point safety belt approved in
accordance with ECE R16 or equivalent standardT
The proper threading of the seat belt is essential to
your child's safetyT The seat belt must be threaded
along the blue markings on the EasyFixT See the sticker
outlined in blue on the topside of the EasyFixT
WARNING!
Never thread the belt in any other way!
Yes
No
Yes
Yes
Yes*
Blue
No
Yes
13