Installation - FOGAL Alaska Mode D'emploi Original

If this point is not observed, some problems may occur as extreme
I
consumption, ice on the evaporator and temperature loss.
The cabinet has to be placed in a dry place, avoiding direct contact
to sunlight and heat sources like radiators, fans, doors or air current
(image > 3).
If these instructions are not observed, the above mentioned pro-
GB
blems may occur.
The evaporation of the defrosting waste water is automatic.
F
D
In the remote models it is necessary to provide a connection system
for the condensate water.
NL
Do not place the cabinet at less than 8 cm from the wall or from any
!
do not block up
the aspiration grill
8
image > 4
30
other thing that could prevent the cabinet from having a proper air
circulation.
It is strictly forbidden to place any kind of thing on the upper part of
the cabinet.
Use the spacers supplied with the cabinet.
An inadequate air circulation around the cabinet could cause con-
densate formation and problems in the refrigerating yield.
Do not block up the aeration grills, the aspiration grills and the air
flow slit (image > 4).
Noise level
The noise level of the cabinets does not exceed 70dB(A)
Transport
The cabinets are supplied with four metallic base supports. The use
of a forklift to lift the cabinets up and to move them in a safe way is
allowed.

6. INSTALLATION

After having unpacked the cabinet, remove the metallic base sup-
ports as per the attached instructions.
Please note: while removing the metallic base supports the cabinet
could be temporarily unstable.
Be very careful and remove ALL the four supports.
31
I
GB
F
D
NL