Reloop sPod platinum Mode D'emploi page 9

COMPUTER CONNECTION
WINDOWS:
1. Use the included USB cable to plug the Reloop sPod
Platinum into your computer. Once the Reloop sPod
Platinum is plugged in, the power LED on the front of
the microphone will glow blue.
2. Your computer will automatically detect the Reloop sPod Platinum, but it may not set it as default sound device. Go to the
Control Panel and then double click on the Sounds and Audio Devices icon.
3. Click on the Audio tab in the drop-down menu under Sound playback. Select USB PnP Sound Devices as the default device.
4. In the drop-down menu under sound recording, select USB PnP sound Device as the default device.
5. Click OK to save your changes and exit.
*Reloop sPod Platinum can be used with Windows 7 /Windows 8/Windows 10/Windows VISTA/Mac OS 9 or higher.
MAC OS X:
1. Use the included USB cable to plug the Reloop sPod Platinum into your computer. One end of the cable corresponds with the
USB port on your computer. Once the Reloop sPod Platinum is plugged in, the power LED on the front of the microphone will
glow blue.
2. Your computer will automatically detect the Reloop sPod Platinum, but it may not set it as default sound device. To set the
Reloop sPod Platinum as the default,go to System Preferences and select Sound.
3. Click on Input tab and then click on USB PnP Sound Device to select it as the default sound input device.
4. Click on the Output tab and then click on USB PnP Sound Device to select it as the default sound output device.
5. From the Sound window, you can adjust the computer's input and output volumes, adjust the stereo balance, and select to
show the volume in menu bar.
TECHNICAL SPECIFICATIONS
Type:
Polar pattern:
Sensitivity:
Frequency response:
Max sound pressure level:
S/N ratio:
0
330
300
270
240
210
180
Subject to alterations.
Illustrations similar original product.
Misprints excepted.
Side address condenser microphone
Cardioid
-60dB +- 5dB (1V/u bar)
50 Hz – 18 KHz
120 dB
59 dB
30
60
90
120
150
1KHz
CLIO