Fisher & Paykel DCS HD30 Instructions D'installation page 17

Prepare the downdraft unit for the intended blower
2
Internal blower
Remove the 10" (254 mm) blower connection plate from the front of the downdraft
● ●
unit Fig.1.
Attach the over counter mounting brackets in place with the two 3/ 1 6" (5 mm) screws
● ●
provided Fig.2.
Screw the support leg mounting brackets to the side of the downdraft unit using two
● ●
5/ 1 6" (8 mm) screws each, do not fully tighten the screws. The brackets are different
for the right and the left side. Attach them with mounting clip (A) pointing up.
Remote blower
The downdraft unit comes ready for installation with the 10" (254 mm) remote blower
● ●
connection plate installed on the front of downdraft unit and the cover plate installed
onto the back.
To connect the remote blower to the back of the downdraft unit swap the plates over
● ●
(see Fig. 3 and 4)
Attach the over counter mounting brackets in place with the two 3/ 1 6" (5 mm) screws
● ●
provided Fig.2.
Screw the support leg mounting brackets to the side of the downdraft unit using two
● ●
5/ 1 6" (8 mm) screws each, do not fully tighten the screws. The brackets are different
for the right and the left side. Attach them with mounting clip (A) pointing up.
Fig.1
Fig.3
INSTALLATION INSTRUCTIONS
Fig.4
Fig.2
2 x
EN
A
4 x
15