FILLING AND MAINTENANCE
pOOL FILLING AND NOTICE
1. Thepoolmustbefilledpossiblywithcleanwater.
At the beginning of the filling phase (in the rectan-
gular models) when the sides are not sustained by the
water pressure, the pool structure will be folded in at
the corners; we recommend placing a piece of cardbo-
ard at the corners between the folded sides to avoid
scuffing the contact points.
The water level (in all models) must be kept between
10 and 5 cm. below the toprail of the pool in order that the water circulates
efficiently. When the pool is full you can start up the filtration system.
2. Chlorinemustbealwayspoured
into the skimmer with the pump
switched on in order to avoid that
partsofsolidechlorinegetincon-
tact with the sidewalls or with the
bottomofthepool.
The contact between chlorine and
thelinerwillcauseafadingofthe
linercolour,butitwillnotweaken
thestructure.
So you have to pay attention while
pouring the chemicals into
the skimmer.
CHOLINE VAPOUR ARE DANGEROUS, BE CAREFULL AND AVOID TO BREATH
THEM!
3. When you intend to shut the filtration system off for a long period
we recommend to remove any undissolved residue of chlorine from the skimmer.
While dissolving slowly, chlorine would fall over to the bottom of the skimmer
with the above-mentioned effects.
43