Yamaha mLAN16E Mode D'emploi page 15

• (For Windows) When adding a new IEEE 1394 card, right click on the mLAN Manager icon in
the task bar and select "ON".
.............................Refer to "Confirming the installation" in the Installation Guide.
• Is the ACTIVE lamp on the rear panel of the mLAN16E lit (in blue)? If it is not lit, check the fol-
lowings:
- In mLAN Driver Setup, is the Status indicator blue? If not, restart the mLAN16E-equipped
device and re-enable connection by using mLAN Auto Connector or mLAN Graphic Patch-
bay. .......Refer to "Changing settings after installation" in the Installation Guide and
the mLAN Graphic Patchbay Online Manual.
• Has connection been enabled with mLAN Auto Connector and/or Graphic Patchbay? Re-
enable connection if necessary.
.......Refer to "Connecting a Computer to an mLAN device via mLAN" in the
Installation Guide and "mLAN Connection Settings" in the mLAN Graphic
Patchbay Online Manual.
• Have you changed the device? Even if the model is the same, if the actual device is different, it
is necessary to re-enable connection by using Auto Connector and/or Graphic Patchbay.
.......Refer to "Connecting a Computer to an mLAN device via mLAN" in the
Installation Guide and "mLAN Connection Settings" in the mLAN Graphic
Patchbay Online Manual.
• Is there a loop connection? Check the cabling and make sure none of the devices are con-
nected in a loop.
Computer
• There may be a limit on the IEEE 1394 interface of your computer as to the number of ports
that can be used simultaneously. Check how many ports can be used simultaneously.
.......Refer to "Maximum Number of Connected Node" in the mLAN Graphic
Patchbay Online Manual.
• Turn off all devices on the mLAN network (except the computer) and re-connect each device
one-by-one until the device causing the problem is found.
• (For Windows) (When removing the mLAN bus from the [Safely Remove Hardware] setting of
the task bar.) Restart the computer when using mLAN again.
• With Macintosh notebook computers such as the iBook and PowerBook, always first connect
the mLAN16E-equipped device and mLAN cable then turn on the power of the mLAN16E-
equipped device, before starting up the computer.
■ An application, such as a DAW, fails to recognize the mLAN driver (MIDI/audio).
• (For Windows) Make sure mLAN has not been turned off. On the task bar, right-click mLAN
Manager ( ), then select ON.
.......Refer to "Confirming the installation" in the Installation Guide and "mLAN
Connection Settings" in the mLAN Graphic Patchbay Online Manual.
• Make sure the mLAN16E is connected to the mLAN cable and is powered on. Start mLAN Auto
Connector or mLAN Graphic Patchbay, then re-connect the device.
.......Refer to "Confirming the installation" in the Installation Guide and "mLAN
Connection Settings" in the mLAN Graphic Patchbay Online Manual.
• (For Macintosh) To use an iBook or PowerBook in the system, connect the mLAN16E-equipped
device to the Macintosh using an mLAN cable, turn on the power to the mLAN16E-equipped
device, then start the Macintosh.
• Make sure the mLAN settings are correct.
.................................. Refer to "Unable to communicate via mLAN" on page 14."
Computer
mLAN device
mLAN device
: IEEE 1394-equipped device
15