Fisher & Paykel OR36SDBMX Guide D'utilisation page 26

5
FITTING THE SIDE RACKS
1. Place the side racks in oven. Make sure that they are the right way up, as in the illustration, and then insert and tighten the front and
rear fi xing screws.
2. If not already fi tted, fi t the telescopic sliding shelf supports. See "Fitting and removing the sliding shelf supports.
Note: Do not use the fi rst step from the top.
REMOVING THE SIDE RACKS
3. Using a small coin or a fl at-head screwdriver, loosen and remove the front and rear fi xing screws.
4. Remove the side rack.
FITTING AND REMOVING THE SLIDING SHELF SUPPORTS
When fi tting the sliding shelf supports, make sure that you fi t:
- the slides to the top wire of a shelf position on the side racks
- both sides of each pair of slides on the same level.
Important!
Do not use on shelf position 1 or 2.
Remove the side racks fi rst to make removing the sliding shelf supports easier.
Fig. 5.9
26 26
Fig. 5.8
1
2
1
Fig. 5.10