Installation And Connection; Operation And Control - Horizont stallmaster 2 10430 Mode D'emploi

en
Operating instruction for electric fence controller stallmaster 2
in connection with Requirements for electric animal fences in Verbindung Annex BB.1 from the European Safety
Standard EN 60335-2-76 and in Switzerland in connection with the editions to the approval of cow trainer's ar-
rangements for milk cattle according to A93 / 76 of the Federal Office for veterinarian being (attachment A93 / 76)

INSTALLATION AND CONNECTION:

The installation shall be made preferably inside a building but not where there is a risk of fire. In case of outside installation
the controller must be mounted in the vertical position. In case of cowtrainer application the output terminal marked with the
flash is to be connected to the trainer installation. The earth terminal can be connected to the equipotential bonding if there is
any in the area of the cows. If not, the earth terminal must be connected to other metal equipment
in the stable, eg a rack or to a separate earth stake - at least 1m in depth.

OPERATION AND CONTROL:

Plug the mains cable in a 230V socket. After a few seconds a slight tic-tac can be heard. The impulse lamp flashes with the
pulses. With respect to the animals the controller turns off after 2 hours, the pause lamp is now illuminated.
This stand by operation remains for app. 5 hours, then the controller is active again for about 2 hours with the impulse lamp
flashing. This normal operation mode is running on altering between short on and longer stand by time. In case of animal
contact or a short the controller is switched off after 4-5 pulses with the failure lamp flashing now. A restart is only possible
after a new plug off and on with a 30 sec. interval. The output of the unit is adapted to the application in stables.
REQUIREMENTS:
The device complies with the requirements of the EEC directives 2004/108/EC „Electromagnetic compatibility" (CE
marking), 2011/65/EU (RoHS) + 2002/96/EG (WEEE) and also the European Safety Standard EN 60335-2-76 (electric fence
energizers).
Approval in Switzerland within the scope of the testing method and approval procedure for serially made penning systems
and stable facilities (article 7 paragraphs 2 TschG). The stable master 2 type 10430 is also allowed after the 31st of August
2013 as a cow trainer's mains appliance. Besides, the editions must be fulfilled to the approval by cow trainer's arrange-
ments for milk cattle according to A93 / 76 (attachment p. 8) of the Federal Office for veterinarian being.
With investigations with cow trainers in the intermittent application, i. e. within 7 days the electric fence device operates only
2 days, no increase could be ascertained compared with the stock polution of a cow trainer in continuous application.
SERVICE:
A plug in module can be replaced easily by your dealer, where in the event of failure the fault is likely to be on the
printed board. If the supply cord of this energizer is damaged this cord must be replaced by a special supply cord
which is recommended by the manufacturer.
SUBJECT TO ALTERATIONS !
4