Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS FOR THE USER
IT IS NECESSARY THAT ALL THE OPERATIONS REGARDING THE INSTALLATION, ADJUSTMENT
AND ADAPTATION TO THE TYPE OF GAS AVAILABLE ARE CARRIED OUT BY QUALIFIED
PERSONNEL, IN CONFORMITY WITH THE REGULATIONS IN FORCE.
THE SPECIFIC INSTRUCTIONS ARE DESCRIBED IN THE BOOKLET SECTION
The symbols silk-screen printed on the side of the
knob indicate the correspondence between the
knob and the burner.
Automatic start-up without valves
Turn the corresponding knob anticlockwise up
to the maximum position (large flame, fig.1) and
press the knob.
Automatic start-up with valves
Turn the corresponding knob anticlockwise up
to the maximum position (large flame, fig.1) and
press the knob.
Once the burner has been started up, keep the
knob pressed for about 10 seconds.
Using the burners
In order to obtain the maximum yield without waste
of gas, it is important that the diameter of the pot is
suitable for the burner potential (see the following
table), so as to avoid that the flame goes out of the
pot bottom (fig.2).
Use the maximum capacity to quickly make the
liquids reach the boiling temperature, and the
reduced capacity to heat food or maintain boiling.
Maximum
INTENDED FOR THE INSTALLER
Closing
Minimum
1
All of the operating positions must be chosen
between the maximum and the minimum ones,
never between the minimum position and the
closing point.
The gas supply can be interrupted by turning the
knob clockwise up to the closing position.
If there is no power supply, it is possible to light the
burners with matches, setting the knob to the start-
up point (large flame fig.1).
Burners
Auxiliary
Semi-rapid
Rapid
Ultra-rapid
24
Power W
Ø of pots
1000
10-14 cm
1650
16-18 cm
3000
20-22 cm
3500
24-26 cm
2
Publicité
