EUROM THG14000 Manual D'instructions page 26

GAS ODOUR
An odour is added to gas to ensure that leaks can be detected. Gas is heavier than air; try to detect the
odour just above ground level!
 Immediately shut the gas supply.
 Do not do anything that could lead to fire or a spark being created; this could ignite the gas. Do not
switch any electrical components on or off, do not use matches or lighters and do not use your
telephone.
 Keep everyone away from the source of gas and allow plenty of time for it to dissipate. Stay out of the
area during this process! If you continue to smell gas or are not sure of the situation, always call the
fire services.
 Always have gas leaks repaired by professionals!
USE
TURNING THE PATIO HEATER ON
 Turn the valve on the gas bottle to open.
 Push the control button in and turn to PILOT setting.
Keep the button depressed for at least 60 seconds
(around 90 seconds if you have attached a new gas
bottle).
 While pressing the control button, press a couple of
times on the ignition until the pilot light goes on. Keep
the control button depressed for another 30 seconds
in order to activate the thermocouple. You can now
release the control button.If the flame will not ignite,
turn the control button to Off and wait 5 minutes before
a new attempt to inflame will be made.
 Turn the control button to the lowest setting and leave
the patio heater to burn for five minutes. You can then
turn the control button to the desired setting: High =
maximum.
 The pilot light can be viewed and checked via the
peephole with the slider which can be found on the
side of the flame screen.
TURNING THE PATIO HEATER OFF
 Turn the control button to PILOT setting.
 Press the control button in and turn to OFF.
 Close the regulator on the gas bottle completely.
Connecting and exchanging gas cylinder
You need an adjustable spanner to exchange the gas cylinder.
Exchange the gas cylinder outside, without naked fire or sparks in the vicinity. Never turn the gas
cylinder round or lay it down.
 Check the new gas cylinder for damage and check the connection on the pressure regulator for
perfect shut-off. If you suspect damage or a flaw, exchange the gas cylinder at your gas supplier.
 Check that the gas tap is shut off both on the empty and the new gas cylinder (the valve knob must be
turned clockwise as far as possible). Check if the sealing gasket of the gas tap on the new gas
cylinder is in good condition. Do not use any additional sealing.
 Lift the gas cylinder container onto the frame and remove the empty gas cylinder.
 Using an an adjustable spanner, unscrew the pressure regulator from the empty gas cylinder.
 Check that the gas hose has no twists or buckles.
Take immediate measures if you smell gas!
- 26 -