Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
Make sure you have access to the following tools before starting to assemble the device:
Open-ended spanners 10, 13 and 17
Adjustable monkey wrench 8 inch
Water pump pliers
Medium screwdriver
Soapy liquid for leak test
Check that all of the components are present using the assembly description.
Step 1
1-1
Place the three bent tubes (that together form the container frame) on
the base, see diagram.
1-2
Use 3 M8 x 16mm bolts to mount the tubes on the base.
Step 3
3-1
Place the gas bottle container over the frame.
G = gas bottle container
Step 4
4-4
Screw pressure regulator (open-ended spanner 17) tight to the end of the gas hose.
H = stay bolt I = headless screw J = washer K = gas inlet L = swivel nut
M = hose N = bolts
A = container frame B = base C = bolt
Step 2
2-3
Place the stand with the attachment plate on top of the container frame.
2-4
Use 6 M6 x 35mm bolts with nuts to mount the stand on the frame.
D = stand E = nut F = bolt
4-1
4-2
4-3
- 23 -
Screw the headless screws
(with the washer in between)
with the other side held fast into
the upper cap of the flame
screen.
Check if the rubber gas hose is
firmly mounted to the underside of the burner and allow
this to drop into the stand.
Place the burner with the operation panel and the flame
screen on the stand and secure with 4 M6 x 10mm
bolts. The 4 bolts must be removed from the bottom of
the burner firstly.
Publicité
