EUROM THG14000 Manual D'instructions page 24

Step 6
6-1 If required mount the two castors to the base of the
patio heater using both bolts, the four
washers and the two nuts.
6-2 Tilt the gas bottle container and allow it to rest on the
frame.
6-3 Close the pressure regulator on the gas bottle and screw
the fastener on securely with the adjustable monkey
wrench (see: connecting and exchanging gas cylinder).
6-4 Place the gas bottle within the frame.
6-5 Let the container drop over the frame.
T = pressure regulator U = gas bottle
Your patio heater is now assembled.
In order to conduct a comprehensive leak test: cover the entire gas 'pathway' with the soapy solution and
check for leaks. Pay particular attention to connection points and risky areas!
Only when you are 100% sure that there are no gas leaks can you use the patio heater.
Please refer to chapter: Checking for leaks.
LOCATION AND INSTALLATION
 The patio heater is intended for outdoor use. Never use it in areas where this is a risk of explosion,
such as rooms where gas or other flammable substances are stored.
 Make sure, at all times, that there is sufficient air ventilation.
- 24 -
Step 5
5-1 Remove protective cover before assemble.
5-2 Place the 3 segments that make up the reflector cap with the 9
bolts, washers and cap nuts
5-3 Screw the 3 washers over the pins on the flame screen and
place the reflector cap above the burner so that the pins fit
through the holes and the cap rests on the bolts.
5-4 Place 3 washers over the headless screws and secure this
whole construction above the cap with the 3 wing nuts.
P = cap nut Q = central plate R = segment S = bolt
on the central plate and secure.