Publicité
Solving operating problems
PROBLEM
Small puddle of
water from under
the machine
Cycle time
longer than
usual/Inaccurate
time reading/
Adjustment of
time remaining
during cycle
Detergent or
fabric softener
remaining
in detergent
dispenser at the
end of the cycle
TROUBLESHOOTING
POSSIBLE CAUSES
Inlet hose or drain hose
leaking.
Lots of suds.
Detergent dispenser
blocked.
Detergent dispenser
drawer not fully closed.
Damage to door seal.
Wash time is approximate.
Low water pressure or
flow rate.
Out of balance or
oversudsing.
Washing a large load.
Selecting various options.
Detergent drawer not
properly closed or was
opened part way through
the cycle.
Dirty or blocked detergent
dispenser.
Liquid sitting at the 'Max'
level at the end of the
cycle indicates a blockage.
Dispenser over loaded
with detergent.
WHAT TO DO
Check inlet hose(s) and the drain
hose are correctly attached and not
damaged.
Suds may have leaked and then
dissolved.
Clean detergent dispenser drawer
(refer to page 37).
Close detergent dispenser drawer
fully and ensure it remains closed
during the cycle.
Check seal inside door for damage. If
it sustains any damage it will need to
be replaced.
Wash time may be influenced by a
number of factors (refer to page 22).
Ensure that inlet hose filters are not
blocked.
Recovery from out of balance or
oversudsing will extend cycle time
(refer to pages 40 – 41).
Be aware that it will take longer for
the machine to fill.
Be aware that some options will
extend cycle time.
Ensure the detergent dispenser
drawer is fully closed at the start
of the cycle and remains closed
throughout the cycle.
Clean the detergent dispenser (refer
to page 37).
Clean the fabric softener dispenser
(refer to page 37).
Clean out remaining detergent
and refer to page 28 for dosing
information.
EN
45
Publicité
