To warm your crockery
1 Load your crockery carefully into the drawer.
(see 'Loading' for suggestions on positioning of crockery)
Turn the warming drawer on
2 Press the
button to turn the warming drawer on.
The halo will glow red while the drawer is on.
Select a temperature
3 Select a temperature by pressing one of the temperature control buttons.
The halo will glow red while the drawer is on.
The warming drawer has three temperature settings
●
(which are approximate depending on the load):
1 (
) = 113°F (45°C) 2 (
Only one temperature can be selected at a time.
●
If no temperature setting is selected the warming drawer will default
●
to setting 2 (
Note: You may change the temperature setting during use.
Set the timer (optional)
4 The warming drawer has two pre-programmed timers (1 hour (
and 2 hours (
To start the timer press one of the timer buttons.
●
The halo will glow red while the timer is on.
●
Only one timer can be selected at a time.
●
At the end of the timer period the warming drawer will switch off
●
and both the on/off and timer halos will go out.
To turn the timer off during use, press the timer button again.
●
The drawer will continue to operate until switched off.
NOTE: You may turn a timer on, or change the timer selection, at any stage during use.
If no timer is selected the warming drawer will remain on until switched off.
●
However, for safety reasons, after 12 hours of continuous use the warming drawer
will automatically turn off.
Close the drawer
5 Close the drawer fully. This ensures the most efficient heating.
Your warming drawer has a 'soft closing' mechanism.
●
When the drawer is closed, the on/off light is visible through the drawer front.
●
Removing warm crockery
6 Crockery can be removed at any time. Refer to the following table for suggested
heating times.
IMPORTANT!
Always use oven mitts to remove heated crockery from the warming drawer.
6
USING YOUR WARMING DRAWER
) = 131°F (55°C) 3 (
).
2h
).
) = 149°F (65°C)
1h
)