Safety And Warnings - Fisher & Paykel HC24PHTX1 Guide D'utilisation

33 lb (15 kg)
(HC24)
35 lb (16 kg)
(HC30)
37 lb (17 kg)
(HC36)
IMPORTANT SAFETY INSTRUCTIONS
READ THE ENTIRE SET OF INSTRUCTIONS BEFORE INSTALLING OR USING
THIS APPLIANCE. Manuals can also be found on our website fisherpaykel.com.
CAUTION: For general ventilating use only. Do not use to exhaust hazardous
● ●
or explosive materials and vapors.
WARNING! To reduce the risk of fire, electric shock, or injury to persons, observe
● ●
the following:
– Use this unit only in the manner intended by the manufacturer. If you have
questions, contact the manufacturer. For residential use only.
– Before servicing or cleaning unit, switch power off at service panel and lock
the service disconnecting means to prevent power from being switched on
accidentally. When the service disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to the service panel.
– Installation work and electrical wiring must be done by qualified person(s)
in accordance with all applicable codes and standards, including
fire-rated construction.
– Sufficient air is needed for proper combustion and exhausting of gases
through the flue (chimney) of fuel burning equipment to prevent back drafting.
Follow the heating equipment manufacturer's guideline and safety standards
such as those published by the National Fire Protection Association (NFPA),
and the American Society for Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code authorities.
4

SAFETY AND WARNINGS

WARNING!
!
Weight Hazard
The ventilation hood is heavy. Please ensure adequate care is taken
when installing the ventilation hood to prevent personal injury.
The ventilation hood must be installed onto a solid wall, stud,
beam or truss.
Weight of the products are 33 lb (15 kg) HC24 /
35 lb (16 kg) HC30 / 37 lb (17 kg) HC36.
WARNING!
!
Electric Shock Hazard
Always disconnect the appliance from the mains power supply
before carrying out any maintenance or repairs.
Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction.
Failure to do so can result in death, electric shock, fire or injury
to persons.