Preparing Your Flash For Use; Power Supply Connection - Starblitz SHARK200 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Preparing Your Flash for Use

1. Select a stand or support system of suitable weight and dimensions to ensure
stable operation of the unit.
2. Install Reflector / Protective Cap and Modeling Lamp
- To remove plastic protective cap off, push the latch knob back towards the rear of
the unit and rotate the plastic protective cap anti clockwise.
- Install the modeling lamp by inserting it into the socket.
- Install the reflector where the protective cap was before. Align the three pegs on
the reflector with the three slots, press the reflector in and rotate clockwise until it
locks in place.
- To remove, push the latch knob back towards the rear of the unit and rotate the
reflector anti-clockwise.
 Do not touch the lamp with your bare hands. Oil residue from your fingers can
cause the surface of the lamp to heat unevenly and explode. Use white cotton gloves
or a clean cloth.
 Take care not to damage the flash tube assembly when fitting or removing reflec-
tors or soft boxes. The flash tube is very delicate; avoid unnecessary handling of the
flash tube.
 Always switch off and disconnect from the main supply before fitting and chan-
ging reflectors, inserting the modeling lamp or replacing the flash tube.
 Standard configuration of softbox for Starblitz® SHARK studio flash is SB-030
50*70cm. We do not recommend to install SB-030 square softbox bigger than
60*90cm or SB-038 octagon softbox bigger than diameter 80 cm, or beauty dish
bigger than diameter 460mm.

Power Supply Connection

 Use only the mains leads supplied to connect to the main power.
 Before plugging the power cord into the wall socket, make certain that the power
switch is set to the OFF ("0" position).
EN
FR
ES
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Shark400

Table des Matières