Pentair Flotec EVOTRONIC 350 Manuel D'utilisation page 28

EN
USE AND MAINTENANCE MANUAL
The pump starts and reaches
the pressure level set in the
factory. The RUN/FAULT led is
ON and in green color. In case
the system pressure is "higher
than" or "equal to" the factory
pressure setting, the pump is in
PROGRAMMING
LANGUAGE SETTING:
1. It is possible to change the language by pressing on the SET button
2. Display setting.
By pressing on the button MODE It is possible to change the display configuration and choose between GRAPHIC
mode (a) and TEXT one (b) .
26
stand-by (green led ON), ready to
start if the pressure decreases.
If the pump does not start
4.
properly and does not quickly
reach the working conditions,
then STOP the pump. The pump
a)
b)
could switch to PROTECTION
mode, please see chapter "
QUICK TROUBLE SHOOTING
GUIDE"
Repeat the pump priming
5.
operations