Installation And Connection - Bartscher 135.002 Mode D'emploi

•
Do not lay the cable over carpets or heat insulations. Do not cover the cable.
Keep away the cable from operating range and do not dunk it into water.
•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of the
device and is stable.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
Place the device in an area inaccessible to children.
•
Make sure there is a minimum distance of 15 cm between the wall and the back
and the sides of the device, in order to provide sufficient air circulation
•
Never block the ventilation slots.
•
Wait at least one hour until the refrigerant has settled before connecting the
device to a socket.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
- 25 -