Maintenance - Fisher & Paykel HCB30-6 Guide D'utilisation

Light bulb replacement
IMPORTANT!
Wear gloves to protect against sharp edges.
●
DO NOT TOUCH the light bulb when in use. They may be hot enough to cause injury.
●
Note: Replacement bulbs are not covered by warranty.
To replace the light bulb:
Turn off the range hood and allow the light bulb to cool.
●
Disconnect the power.
●
To remove the light bulb push up and twist counterclockwise.
●
Replace with a new 120V, 50W maximum light bulb (or equivalent dimmable LED)
●
light with a GU10 base.
Repeat steps for the other light bulbs if needed.
●
Reconnect power.
●
If new lights do not operate, ensure the bulbs are inserted correctly before calling
●
a service representative.
Replacing the infra-red heat lamp (optional accessory)
WARNING!
To avoid any electrical shock the installation of the infra-red heat lamp and panel kit
should be done by a qualified electrician and before starting the installation of the
range hood.
Optional infra-red heat lamp panel can be ordered separately and mounted into
your range hood, see the 'Parts and accessories' section.
Turn off the range hood and allow the infra-red heat lamp to cool.
●
Disconnect the power.
●
Remove the infra-red heat lamp bulb by twisting counter clockwise.
●
Replace with a new 120V, 175W maximum infra-red bulb with a E26 screw in fitting.
●
Repeat steps for the other lamp if needed.
●
Reconnect power.
●
If new lamps do not operate, ensure the bulbs are inserted correctly before calling
●
a service representative.

MAINTENANCE

EN
27