Inserting The Carbon Filters For Circulating Air Mode - Hanseatic SY-6005B2 Manuel D'instructions

Installation
8. Insert a screw 7 with a washer 8 into each of the four holes in
the floor of the cabinet from the top.
9. Place the extraction hood onto the four screws in the floor of
the cabinet from below and screw in place tightly with four
washers 8 and four nuts 9.
10. Screw the incandescent lamp 6 into the socket on the inside of the
extraction hood.
11. Reinsert the filter panels 1a and close.
12. For extraction mode: push the exhaust air hose (not in the scope of
delivery) onto the exhaust air connection 4 and attach using a hose clamp.
13. Insert the mains plug into the socket.
The carbon filters (odour filters) are filled with activated carbon that reduces

Inserting the carbon filters for circulating air mode

the kitchen vapours during cooking. If used regularly, these filters should be
replaced approximately every three months (see "Care and maintenance" –
Carbon filters, page 18).
1a
1. Push the lock on the grease filters 1a backwards and remove the grease
filters 1a carefully downwards.
2. Place the new carbon filters 3 on the two motors and attach firmly by
rotating 90 degrees.
3. Reinsert the filter panels 1a and close.
Preparation
7
4
8
8
9
3
English
15