Hitachi CP-X2514WN Manuel D'utilisation page 190

Connection to the ports
NOTICE ►Use the cables with straight plugs, not L-shaped ones, as the
input ports of the projector are recessed.
►Only the signal that is input from the COMPUTER IN1 or IN2 can be output
from the MONITOR OUT port.
A
COMPUTER IN1,
D-sub 15pin mini shrink jack
<Computer signal>
• Video signal: RGB separate, Analog, 0.7Vp-p, 75Ω terminated (positive)
• H/V. sync. signal: TTL level (positive/negative)
• Composite sync. signal: TTL level
<Component video signal>
• Video signal:
-Y, Analog, 1.0±0.1Vp-p with composite sync, 75Ω terminated
-Cb/Pb, Analog, 0.7±0.1Vp-p, 75Ω terminated
-Cr/Pr, Analog, 0.7±0.1Vp-p 75Ω terminated
System: 480i@60, 480p@60, 576i@50, 720p@50/60, 1080i@50/60
Pin
1 Video Red, Cr/Pr
2 Video Green, Y
3 Video Blue, Cb/Pb
4 (No connection)
5 Ground
6 Ground Red, Ground Cr/Pr
7 Ground Green, Ground Y
8 Ground Blue, Ground Cb/Pb
COMPUTER IN2,
B
Signal
A
C MONITOR OUT
Pin
9 (No connection)
10 Ground
11 (No connection)
A : SDA (DDC data), (No connection)
12
, C : (No connection)
B
13 H. sync / Composite sync., (No connection)
14 V. sync., (No connection)
A : SCL (DDC clock), (No connection)
15
,
B C : (No connection)
Connection to the ports
B
C
⑪ ⑫ ⑬ ⑭ ⑮
⑥ ⑦ ⑧ ⑨ ⑩
① ② ③ ④ ⑤
Signal
3