Changing The Door Opening Direction; Tools Required - Edesa 1CM34NF Mode D'emploi

CHANGING THE DOOR-OPENING DIRECTION:

TOOLS REQUIRED:

A Phillips screwdriver.
PROCEDURE:
1. Unplug the refrigerator and take everything
from the compartment.
2. Take out the screws and remove the bottom
hinge. (Fig. 1)
3. Remove the freezer door.
4. Remove the cover of the central hinge
screws, and loosen the two screws holding it in place. (Fig.2)
5. Remove the refrigerator door.
6. Take out the top hinge pin and fit it on the other side
of the refrigerator. (Fig. 3)
Fig. 3 Top hinge
BEFORE SWITCHING THE REFRIGERATOR ON:
Clean the inside with warm water and bicarbonate of soda. Rinse and dry
carefully.
Wait for 2 hours before starting, to ensure that the motor lubricants have
stabilised.
If the refrigerator has been switched off, wait 4 hours after restarting before
placing food inside.
7. Change the position of the
lower hinge pin.(Fig. 1)
8. If fitted, change the lateral handles to the other side.
9. Reverse this procedure to refit the doors.
Switch the appliance on and check that the sealing strips
seal properly when the door is closed.
5
Fig. 1 Bottom hinge
Fig. 2 Central hinge