First Use; What To Do In Case The Current Feels Unpleasant; Useful Advises; How To Pause The Program - Wintec Easy Band Manuel D'utilisation

EASYBANDMULTI rev. 3.0 170 x 148.qxd 11/02/2004 17.54 Pagina 11

First use

1.Press the ON / OFF key to turn-on the stimulator. The display lights and shows the last performed program. The
intensity indicator shows 0.
2.Select the program you wish to perform by pressing the P key.
3.Increase the used channel intensity pressing the key with the arrow . Increase the intensity until the wished level,
always maintaining a comfortable feeling. To decrease the intensity press the arrow .
4.Each program has a predefined duration. The intensity automatically returns to zero when the program ends.
5.Every time you wish to turn-off the unit, press the ON / OFF key for 3 seconds.

What to do in case the current feels unpleasant

If you feel pinches instead of muscular contraction, stop the program and follow the above indications:
-Take off the Band and be sure that the electrode zone is uniformly wet.
-Check that the electrodes are not damaged.
-When you fasten the Band, be sure that the electrodes have a good contact with the skin and the Band is good dres-
sed around the stomach.

Useful advises

-Be sure that the conducting electrodes are always wet before using.
-If skin irritation should occur, treatment should temporarily discontinued. Often this effect is because the wet electro-
des dry.
-A decrease of electric impulse effect could occur because an excessive perspiration. Wipe your skin with a cleaned
cloth.
-Take a pause of at least 5 hours between two working sessions.

How to pause the program

You can pause the program by pressing the ON / OFF switch. Start the stimulation by pressing the On / OFF switch
again. The program continues where the stimulation was shut off.
It is proihibit the reproduction and the copy of this manual without written permission of producer. REV. ING. 3.0
9