St400 St400M Operation; Menu Directory - OHAUS ST400 Manuel D'instructions

ST400 & ST400M Portable Meter
3

ST400 ST400M OPERATION

Long press button for 2 seconds to turn on the meter.
After turning on the meter, the default mode is pH mode, press ▲ button and ▼ button to switch
between pH and mV, press
button to switch between Conductivity, TDS, Salinity, Resistivity*.
3.1

Menu directory

The menus of first and secondary directory for STARTER 400/400M:
System
settings
pH Settings
Setup
Conductivity
Settings*
Sensor
management
Data
management
Factory reset
User help
*Only applies to ST400M portable meter
button to switch to conductivity mode, press ▲ button and ▼
User ID
Sample ID
Language
Date & Time
Backlight
Beep
Auto power off
Temperature compensation
Temperature
Temperature unit
Buffer group
Continuous measurement
End point
Sensor ID
Calibration standard
Reference temperature
Temperature unit
Alpha-Coefficient
TDS factor
End point
Sensor ID
Review
Create
Delete
Review
Delete
Reset settings
Reset all
EN-9