Installing The Anti-Tip Device; Leveling The Range; Electrical Connection Requirements; Engaging The Anti-Tip Device - LG LSE5615 Serie Manuel Du Propriétaire

14 INSTALLATION

Installing the anti-tip Device

WarNING
Tip - Over Hazard
A child or adult can tip the range and
be killed. Verify the anti-tip bracket
has been installed. Ensure the anti-tip
bracket is engaged when the range
is moved. Do not operate the range
without the anti-tip bracket in place.
Failure to follow these instructions
can result in death or serious burns to
children and adults.
To check that leveling leg is
inserted into anti-tip bracket,
grasp the top rear edge
of the range and carefully
attempt to tilt it forward.
Screw must
enter wood or
concrete
Locate the anti-tip bracket using the template
An anti-tip bracket is packaged with the template.
The instructions include necessary information to
complete the installation. Read and follow the range
installation instruction sheet (template).

Leveling the range

Level the range by adjusting the leveling legs with a
wrench. Extending the legs slightly may also make it
easier to insert the rear leg into the anti-tip bracket.
Use a level to check your adjustments. Place the level
diagonally on the oven rack, and check each direction
for level.
First check direction .
Then check direction . If the level doesn't show level
on the rack, adjust the leveling legs with a wrench.
Leveling
Anti-tip
leg
bracket
Anti-tip
bracket
Wall plate
2
1
Electrical Connection
requirements
The range must be installed in accordance with Local
and Canadian Electrical Codes (latest edition). See
rating plate for total connected Amp rating. This model
was shipped direct from the factory with Service cord
attached. There are no range connections necessary.
NOTE
Only a range cord rated at 40 amps with 120/240
minimum volt range is required. If a 50 amp range
cord is used, it should be marked for use with 1
diameter connection openings.

Engaging the anti-tip Device

• Move the range close enough to the opening to plug
into the receptacle.
• Slide the range into position ensuring that the back leg
slides under the anti-tip bracket. The range should sit
flush against the back wall when properly installed.
• Carefully attempt to tip the range forward to ensure
that the anti-tip bracket is engaged properly. If properly
installed, the anti-tip bracket will prevent the range
from being tipped. If the range can be tipped, reinstall
the range until the anti-tip bracket is properly installed
and the range will not tip forward.
• Turn on electrical power. Check the range for proper
operation.
3 / "
8