Wiring Connection - Ground Zero NUCLEAR GZNA 2800X Mode D'emploi

Wiring Connection

A. CONNECTING THE POWER (Fig.1)
CAUTION: AS A PRECAUTION, IT IS ADVISABLE TO DISCONNECT THE VEHICLE'S BATTERY
BEFORE MAKING CONNECTION TO THE +12 VOLTS SUPPLY WIRING.
2GAUGE (min. 20mm ) (Thicker if planning for additional Amplifiers) wire is recommended both the power and
ground wires. 12Gauge, for the remote turn-on wire. Both types are available at most Mobile Audio Dealers or
Installation Shops.
(1) GROUND: To Vehicle Chassis To avoid unwanted ignition noise caused by ground loops, it is essential that
the Amplifier be grounded to a clean, bare, metal surface of the vehicles chassis.
NOTE:
GROUND WIRE SHOULD NOT BE EXTENDED MORE THAN 3 FT. (1 METER).
(2) +12 Volt (Fused) Constant Power: To Battery (+) Due to the power requirements of the Amplifier, this
connection should be made directly to the positive (+) terminal of battery. For safety measure, install an in-line
Fuse Holder as close to the battery positive (+) terminal as possible with an ampere rating: not to exceed total
value of fuses in Amp.
(3) Remote Turn-On Input: To Power Antenna output of Car Stereo
This Amplifier is turned "ON" remotely when the vehicle's stereo is turned "ON".
NOTE: IF YOUR RADIO DOES NOT HAVE +12 VOLT OUTPUT LEAD WHEN THE RADIO IS
TURNED ON, THE "REM" TERMINAL ON THE AMPLIFIER CAN BE CONNECTED TO VEHICLE'S
ACCESSORY CIRCUIT THAT IS LIVE WHEN THE KEY IS "ON".
Warning
Investigate the layout of your automobile thoroughly before drilling or cutting any holes. Take care when you
work near the thanks, lines, or hydraulic lines, and electrical wiring. Don't mount this system so that the wire
connections at unprotected or are subject to pinching or damage from nearby objects.
The +12 V DC power wire must be fused at the battery positive terminal connection. Before making or breaking
power connections at this system power terminals, disconnect the +12 V wire at the battery end.
Confirm your radio / cassette player and / or other equip is turned off while connecting the input jacks and
speaker terminals.
If you need to replace the power fuse, replace it only with a fuse identical to that supplied
with the system. Using a fuse of different type or rating may result in damage to this system
which isn't covered by the warranty.
5 6