Varan NETB-02 Manuel D'utilisation page 14

INJECTION PRECAUTIONS
Fluid can penetrate the skin at 100 PSI pressure. Fluid escaping under pressure from the tool has sufficient force to
penetrate your clothing and skin. Follow the precautions below to avoid an injection injury.
1.
Always check for leaks wearing a face shield, safety goggles, rubberized gloves and protective clothes.
2.
Release all pressure from the system before you inspect it.
3. Do not use your hands to detect a fluid leak. Use a large piece of wood, cardboard or paper and watch for
discoloration.
4.
Replace damaged parts with identical manufacturer's components to ensure it is rated to handle the pressure.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the missing part before operating. Failure to do
so could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for damage. Make sure that all items in the
Identification Key are included.
SPECIFICATIONS
The 16 Ton Hydraulic Pipe Bender can bend pipes with a diameter ranging from 1/2 to 3 in. The moveable rollers
allow bend angles from 35º to 90º.
IDENTIFICATION KEY
A. Roller, 2 Pieces
B. Bottle Jack
C. Hex Bolt, 2 Pieces
D. Roller Shaft, 2 Pieces
E. Frame
F. Springs, 2 Pieces
G. Handle (For Jack)
H. 1/2 in. Bending Die
I. 3/4 in. Bending Die
J. 1 in. Bending Die
K. 1-1/4 in. Bending Die
L. 1-1/2 in. Bending Die
M. 2 in. Bending Die
N. 2-1/2 in. Bending Die
O. 3 in. Bending Die
P. Hitch Pins for Roller Shafts, 2 Pieces (Not shown)
Max. Bending Thickness
Max. Bending Capacity (dia.)
Jack Capacity
Ram Stroke
Dies
Dimensions
Size Range
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
3/16 in. (4.5 mm)
3 in.
16 ton
5-1/2 in.
1/2, 3/4, 1, 1-1/4, 1-1/2, 2, 2-1/2 and 3 in.
25-1/2 x 7-7/8 x 22-7/8 in.
1/2 to 3 in.
T: 00352/26908036 – F: 00352/26908040
NETB-02