koban KDP7 Mode D'emploi page 43

Start
1. Aim the detector toward the desired detection pattern.
2. Switch on the power.
3. Warm up KDP7 for about 1 min.
4. Have someone walk across the pattern from outside of coverage pattern
until the light turns on.
5. Adjust sensor head aiming to the direction to be detected (See FIG.13).
6. Adjust METER knob gently to the distance to be detected. Setting knob to
"-", sensor detects the smallest "Field of View". Setting knob to "+",
sensor detects the largest "Field of View" (See FIG.11).
7. Adjust TIME knob gently. The min setting at "-" is about 6sec, the max
setting at "+" is about 12min (See FIG.11).
8. Adjust LUX knob gently to the value to be lighted on. The preset value is
at " " before ex-factory. " " stands for full daylight level, and " "
stands for the dusk light level (See FIG.11).
9. Repeat step 4 to 8 until the desired detection range is reached.
www.grupotemper.com
Walk Test
Finish
KDP7 150
FIG.12
FIG.13
Motion detector light control
Finish
Start
KDP7 180
60 O
Instructions manual |
KDP7
43