Tassimo vivy 2 TAS140 Serie Mode D'emploi page 14

h
Troubleshooting
The following table contains solutions to problems or faults which may occur during
operation of the appliance and that can be easily rectified at home. If you are not satis-
fied with the solutions provided here, please contact our Customer Service department.
Further customer service information can also be found online:
www.tassimo.com
www.bosch-home.com
Problem
The appliance is not
working and none of the
display elements (LEDs)
are lighting.
The brewing starts,
however there is no
beverage dispensed.
The brewing will not
start.
The brewing unit cannot
be closed.
The brewing unit cannot
be opened.
en 10
C7_TAS14_TEXT_EU_8001224649.indb 10 C7_TAS14_TEXT_EU_8001224649.indb 10
Cause
The appliance has no
power supply.
The water tank is not
inserted correctly.
The water tank was
removed during the
brewing stage or there is
air in the system.
The float in the water
tank is stuck.
No T DISC inserted.
The appliance does not
recognise the T DISC bar
code.
The brewing unit is not
closed properly.
The appliance was not
plugged in when the
T DISC was inserted.
The piercing unit and/or
the T DISC support have
not been correctly
inserted.
The T DISC has not been
correctly inserted.
The brewing unit is not
closed properly.
The brewing unit is still
locked.
Solution
Check to see whether the appliance is
connected to the mains.
Check that the water tank is correctly inserted.
Start the cleaning process with the yellow
Service T DISC. Please refer here to the section
First Time Use, Steps 2 – 13.
Clean the water tank and free the float.
Check that a T DISC has been inserted.
Clean the T DISC reading window with a soft,
damp cloth.
Smooth out the foil of the T DISC with your
finger so that the bar code can be read.
Use a new T DISC.
If the problem persists, contact the TASSIMO
careline.
Clean the brewing unit with a soft, damp cloth,
paying particular attention to the lid area.
Insert a new T DISC and check that the
appliance is plugged into the power supply
before inserting the T DISC.
Press the piercing unit into its holder using
both thumbs and check the position of the
T DISC support.
Replace the damaged T DISC with a new one.
Place the T DISC with the printed side facing
downwards so that the tab is resting in the
intended slot.
Clean the brewing unit with a soft, damp cloth,
paying particular attention to the lid area.
Press the lid down until it audibly clicks into
place.
Wait until the Status LED S has stopped
blinking before attempting to open the brewing
unit.
If the brewing unit stays locked, contact the
TASSIMO careline.
21.06.2021 12:38:13 21.06.2021 12:38:13