Overload Protection - HP Autozubehor 20361 Mode D'emploi

To stop your grinder:
1. Release the on/off switch when the switch button is not locked at "on· position. Or press at
the end of the switch button to make it spring back when the switch button is locked at ·on·
position.
For Proper Operations
t. Before starting the grinder, put on safety glasses and make sure that the grinding wheel,
guard and the tool are in good condition and correctly fitted.
2. Always hold the tool firmly with one hand on the rear handle and the other on the side
handle.
3. Turn the angle grinder on and then apply the grinding wheel to the workpiece.
4, In general, keep the edge of the wheel at an angle of about 30
for finishing.
5. Move the grinder back and forth or up and down over the work area.
6. Use just enough pressure to keep the grinder from chattering or bouncing.
7. Avoid overloading the tool for a long time, heavy pressure will decrease its speed and put a
strain on the motor.
8. Lift the grinder away from the workpiece before turning your grinder off.
WARNING!
Never use your grinder without wearing eye protection. Following this rule will reduce the risk
of serious personal injury.
DANGER!
1. Never attach a wood cutting or carving blade of any type to this angle grinder.
2.
Never use your grinder with guard removed.
Failure to follow this rule could result in serious personal injury.
3.

OVERLOAD PROTECTION

The power cutter is fitted with an overload/overheat protection device. When the tool is
forced to work at an excessive load, the protection device will be activated automatically
11
°
for roughing and about 15
°