Adjusting The Wheel Guard - HP Autozubehor 20361 Mode D'emploi

Adjusting the Wheel Guard

This tool is fitted with a wheel guard. The closed segment of the guard can be adjusted to
different angles.
a)Pull the quick release lever toward outside so as to enlarge the circular collar of wheel
guard.
b)Turn the wheel guard to a desired angle. Pull back the quick release lever to lock the
guard.
c) Make sure the guard is firmly secured in place. lf the guard is too loose after pulling back
the quick release lever, pull up the lever. properly adjust the nut on the guard and pull
back the lever again.
This angle grinder is designed for the following purposes:
1. Removal of casting burrs and finishing on various types of steel, bronze. aluminum
materials and castings.
2. Beveling and finishing weid seams
J. Grinding of welded sections cut by means of welding.
�- Grinding of synthetic resin bricks, marbles etc.
5. Cutting !hin wall tubes and small size meta! materials.
Never cover air vents. They must always be open for proper motor cooling.
CAUTION!
To your grinder:
start
1. Push the switch button forward to start the tool.
2. For continuous operation. push the switch button forward to the end. press the switch
button at its front and gently release it so that it is locked at ·on
OPERATION
10
• position.