HP Autozubehor 20361 Mode D'emploi page 20

Please refer to fig.1 to familiarize yourself with the major components of this tool before
using it.
1. Sonnet
2. Spindle Lock
3. Switch Button
4. Battery Pack
5. Charger
CAUTION! Always be sure that the !ool is switched oft before assembly, including
insertion or removal of the battery pack.
lnstalling or removing battery pack
1. To remove the battery pack, withdraw itfrom the tool while depressing the tabs on both
sides of the battery pack.
2. To insert the battery pack. align the ribs on the top of the battery with the grooves
in the housing and slide it into place. Always insert it all the way until it locks in place
with a little click. Lightly pull on the battery pack to ensure it is locked into place and will
not accidentally fall out of the drill, causing an injury.
3. Do not use force when inserting the battery pack. lf the battery does not slide in easily,
is not being inserted correctly.
lnstalling the bonnet
1. Depress and hold down the spindle lock. To prevent damage to spindle or spindle lock,
always allow motor to come to a complete stop before engaging spindle lock.
2. Turn bonnet in anti-clockwise direction.
3. Do not over tighten it.
FEATURES
5
ASSEMBLV
9
•
it