Programming - IFM Electronic efector 500 PN7000 Notice Utilisateurs

Programming

1
Mode/Enter Set
Mode/Enter Set
2
3
Mode/Enter Set
Change more parameters:
4
Start again with step 1.
*Decrease the value: Let the display of the parameter value move to the
maximum setting value. Then the cycle starts again at the minimum setting
value.
Select the display unit (Uni) before setting values for the parameters SPx
and rPx. This avoids rounding errors generated internally during the conversi-
on of the units and enables exact setting of the values.
Setting at the factory: bAr.
If no button is pressed for 15 s during the setting procedure, the unit returns
to the Run mode with unchanged values.
The unit can be electronically locked to prevent unwanted adjustment
of the set parameters: Press both pushbuttons until
To unlock: Press both pushbuttons until
delivered from the factory in the unlocked state.
With the unit in the locked state
to change parameter values.
20
Press the Mode/Enter button
several times until the respective
parameter is displayed.
Press the Set button and keep
it pressed. The current parameter
value flashes for 5 s,
then the value is increased*
(incremental by pressing briefly or
scrolling by holding pressed).
Press the Mode/Enter button
briefly (= acknowledgement).
The parameter is displayed again,
the set parameter value
becomes effective.
Finish programming:
Wait for 15 s or press the
Mode/Enter button until the current
measured value is indicated again.
is displayed. Units are
is indicated briefly when you try
is displayed.