RIDGID K-750 Mode D'emploi page 12

K-750 Drain Cleaning Machine
AUTOFEED Size Setting
Figure 9 – AUTOFEED Size Setting
7. Take the drain cleaning machine to the work area
along the clear path. If the machine needs to be
lifted, use proper lifting techniques. Use care moving
equipment up and down stairs, and be aware of pos-
sible slip hazards. Wear appropriate footwear to help
prevent slips.
8. Position the drain cleaning machine so that the K-750
cable outlet is within 3 feet of the drain access. Great -
er distances from the drain access increases the
risk of the cable twisting or kinking. If the machine
cannot be placed with the cable outlet within 3' of the
drain access, extend the drain access back to within
3' of the cable outlet with similar sized pipe and fit-
tings. Improper cable support can allow the cable to
kink and twist and can damage the cable or injure the
operator. See Figure 10. If using front guide hose,
place machine so that at least 6" of guide hose can be
placed in drain opening.
Figure 10 – Example of Extending Drain to Within 3' of
Cable Outlet
1.800.561.8187
10
9. Tilt the machine forward and use your foot to rotate
Figure 11 – Setting Kickstands
10. Evaluate the work area and determine if any barriers
11. Select proper tool for the conditions.
www. .com
one kickstand at a time to the backside of the wheel.
The machine should firmly rest on the kickstands.
The kickstands stabilize the machine and help prevent
tipping or walking during use. If working on soft ground,
it may be necessary to place wood or other solid ma-
terial under the drain cleaner for proper support.
are needed to keep bystanders away from the drain
cleaner and work area. The drain cleaning process can
be messy and bystanders can distract the operator.
If the nature of the obstruction is unknown, it is good
practice to use a straight or bulb auger to explore the
obstruction and retrieve a piece of the obstruction for
inspection.
Once the nature of the obstruction is known, an ap-
propriate tool can be selected for the application. A
good rule of thumb is to start by running the smallest
available tool through the blockage to allow the backed
up water to start flowing and carry away the debris and
cuttings as the drain is cleaned. Once the drain is open
and flowing, other tools appropriate for the blockage
can be used. Generally, the largest tool used should
be no bigger than the inside diameter of the drain
minus one inch.
Proper tool selection depends on the specific cir-
cumstances of each job and is left to the users'
judgement.
information@itm.com